Fire inspection equipment · 10-in-one field kit
Fire Safety Inspection Box - 10-Piece Professional Fire Inspection Toolkit
One portable case containing every instrument needed to check escape routes, emergency lighting, alarm audibility, hydrant and sprinkler pressure, electrical leakage and detector response - in a single inspection round.
What Is Inside the Box
| Instrument | Fire Safety Inspection Use |
|---|---|
| Tape Measure | Verify evacuation-route widths, door and exit clearances, detector spacing and hydrant placement against approved drawings and code minimums. |
| High-Intensity Flashlight | Inspect dark plant rooms, shafts, ceiling voids and battery rooms; check exit-sign visibility during power-failure conditions. |
| Laser Rangefinder | Measure travel distance to exits, smoke-detector coverage areas and fire-compartment dimensions quickly and without ladders. |
| Digital Illuminance Meter | Test emergency lighting illuminance along escape routes, stairwells and exits to confirm regulatory minimum levels. |
| Digital Sound Level Meter | Measure fire alarm sound pressure at occupied positions - typically at least 65 dB (or 15 dB above ambient noise) - to verify audibility. |
| Digital Anemometer | Check smoke-exhaust outlet air speeds and stairwell pressurization differences for smoke-control system performance. |
| Fire Hydrant Pressure Test Connector | Measure static and residual pressure (and flow) at hydrant outlets to confirm the water supply still meets design values. |
| Sprinkler End-Point Test Connector | Simulate the most unfavorable sprinkler point: verify end-point pressure and that the water-flow alarm triggers within the required time. |
| Leakage Current Detector | Locate insulation faults and leakage currents in distribution boards and circuits - an early, measurable warning of electrical fire risk. |
| Integrated Smoke-and-Heat Combo Tester | Function-test smoke detectors and heat detectors in one instrument: simulated smoke and controlled heat trigger either sensing type without aerosol mess. |
Who Uses This Kit
Frequently Asked Questions
What is a fire safety inspection box used for?
A fire safety inspection box consolidates the ten instruments an inspector needs on site - dimensional measurement, emergency lighting and alarm sound verification, hydrant and sprinkler pressure testing, electrical leakage detection and smoke/heat detector function testing - so a full inspection round can be completed without returning to the office for equipment.
Why does the kit include both a smoke and a heat detector tester in one device?
Most installed points are either smoke detectors or heat detectors, and inspections must function-test both types. An integrated smoke-and-heat combo tester triggers either sensing principle in one pass, halving the instrument count and the time per detector.
How often should sprinkler end-point tests and hydrant pressure tests be performed?
Practice follows NFPA 25 and equivalent local codes: sprinkler end-point flow and alarm response are verified quarterly to annually depending on system type, and hydrant flow/pressure testing is typically performed annually - always confirm the schedule required by the local authority having jurisdiction.
Why is a leakage current detector part of a fire inspection toolkit?
Electrical faults are among the leading causes of fire, and current leakage through degraded insulation is an early, measurable warning sign. A leakage current detector locates such faults in distribution boards and circuits before they become ignition sources.
Order / OEM Inquiry
The kit ships factory-direct from Wanlin Fire Equipment with OEM/ODM branding, instrument calibration documents and a custom instrument configuration on request.
Email: wanlinfirecontrol@163.com · Tel/WhatsApp: +86 132 6167 7119